Run Screen Icons - YSI MultiDO 5400 User Manual

Figure 4.2

Run Screen Icons

Icons identify control, alarm, timer, power, service, and communication informa-
tion. Icons along the top of the Run Screen indicate 5X00 systemwide conditions
- table 4.2. Icons displayed within a sensor window indicate condition(s) specific
to that system - table 4.3.
Notes:
- Control icons display when the control relay(s) is active.
- General alarm icon, buzzer, 5X00 emails, and enabled alarm relay(s) [sensor
and general alarm] remain active until one of the bottom four 5X00 front panel
keys is pressed, regardless if the alarm condition no longer exists.
- Relays, and corresponding icons, that de-energize for Svr Hold, calibration,
and/or factory resets are restored after 30 seconds of completing Svr hold,
calibration, and/or factory resets. For exceptions, see menu specific informa-
tion in this chapter.
- With alarms enabled, alarm icons appear at the systemwide location and
individual system location regardless if a relay is assigned to the sensor alarm
or general alarm system.
Configuring the 5X00
YSI 5X00
76
ICONS Meaning
(systemwide)
RS232 communication
TCP/IP communication
ethernet module is installed and being
used for TCP/IP communication
operating in acceptable DC power range
DC power is ≤ low battery trigger
5X00 is password protected
sensor (data) logs have information
one or more control systems is active
feed timer is active
one or more 10 event timer is active
probe timer needs to be reset
General Alarm is active
table 4.2
Configuring the 5X00
Notes
blinking icon indicates
"force serial port" is
enabled
to view logs
to view active systems
YSI 5X00
77