Install The Weather Shield - YSI MultiDO 5400 User Manual

Figure 3.7
5. Fasten the mounting brackets to the back of the 5X00 enclosure with the
mounting screws - figure 3.2 - page 28.
6. Tighten the screws, securing the brackets to the 5X00.
7. Drill hole in panel for 5X00 enclosure (dimensions provided with kit).
8. Place standoffs between 5X00 mounting brackets and panel surface - figure
3.8- page 32.
9. Secure 5X00 to panel with frame using washers and bolts provided.
Figure 3.8
Installation and Wiring
YSI 5X00
32
10. Reattach lanyard by placing lanyard at proper location of display board
panel. Make sure lanyard is fully seated on display panel boss to ensure
proper clearance when front panel is closed- figure 3.7.
11. Replace four screws to reattach display board panel to front panel enclosure
- figure 3.6.
12. Connect 5X00 display board to ribbon cable - figure 3.5.
13. Secure the 5X00 front panel to the frame using mounting screws. Follow
procedures provided at Close Front Panel - page 41 to secure 5X00 and
protect internal electronics.
14. Tighten the screws, securing the 5X00 to the panel.

Install the Weather Shield

Install the weather shield for outdoor installations. The weather shield can be used
with either a surface or rail mount. The weather shield kit (model number 6505)
includes a weather shield, u-bolts, pre-drilled metal plate, washers, and nuts.
1. First complete steps 1-2 under Surface Mount or steps 1-3 under Rail Mount
depending on the type of installation. Note: You may need to modify the
pre-drilled holes in the weather shield depending on the mounting location.
2. At step 3 (surface mount) or step 4 (rail mount), attach the weather shield
with the metal plate installed securely to the surface or rail. Figure 3.9 shows
the weather shield installed for a rail mounted 5X00.
3. Tighten the screws, securing the weather shield.
Figure 3.9
Installation and Wiring
YSI 5X00
33