Table of Contents
Advertisement
Adjusting of the Hydrostatic
Transmission Cable
The hydrostatic transmission cable is
adjusted as follows:
1.
Remove the transmission cover. Loosen
both screws (one on each side) and lift
off the transmission cover.
2.
Check that the front ball joint on the rod
is fitted in the second hole from the top
on the rear axle's control arm.
3.
Take apart the ball joint for the hydro-
static transmission cable, which is locked
with a locking spring.
4.
Ensure that the forward drive pedal is
pressed down completely.
5.
Switch the arm to the maximum position
and check that the ball and socket in the
ball joint are aligned.
6.
Adjust the socket on the cable as
needed, so that it fits precisely over the
ball on the lever arm.
IMPORTANT INFORMATION
Make sure that the locking spring goes
through both holes in the socket.
7.
Screw in the socket an additional turn.
8.
Assemble the ball joint.
9.
Put the ball joint's locking spring in place.
10. Tighten the lock nut for the socket on the cable.
11. Fit the transmission cover.
Checking and adjusting the throttle
cable, Kawasaki
Check that the engine responds to throttle
increases and that a good engine speed is
attained at full throttle.
If adjustments are necessary, they can be
made as follows for the lower cable:
1.
Loosen the clamping screw for the
cable's outer casing and move the
throttle to the full throttle position.
2.
Check that the throttle cable is mounted
in the correct hole in the lower lever, see
illustration.
3.
Push the throttle cable's outer casing as
far to the left as possible and tighten the
clamping screw.
56
English-
REPAIR INSTRUCTIONS
Transmission cover
The link joint's locking spring
Checking the adjustment of the hydrostatic transmission
cable
Throttle cable Kawasaki
6021-030
8009-203
8009-819
8009-144
Advertisement
Table of Contents
