Installing The Cm Dp Communication Module - Siemens SIMATIC ET 200SP System Manual

Installation

4.3 Installing the CM DP communication module

4.3 Installing the CM DP communication module
Introduction
You need the CM DP communication module to use the CPU with a DP master or DP slave.
Requirements
● The mounting rail is fitted.
● The CPU is installed.
Installing CM DP
To install the CM DP communication module, follow these steps:
1. Install the CM DP to the right of the CPU.
2. Swivel the CM DP towards the back until you hear the mounting rail release button click
into place.
3. Slide the CM DP to the left until you hear it click into the CPU.
Figure 4-3
44
Installing CM DP
Distributed I/O system
System Manual, 12/2015, A5E03576849-AF