Siemens SIMATIC ET 200SP Manual page 74

The following parameters are possible for the module to module communication (MtM)
Table 6- 2 Assignable parameters for module to module communication (MtM)
Parameters
Slot of encoder module
Subslot of encoder module
Encoder module
1
The parameter must be assigned identical with the "Encoder module" parameter under "Parameters in cam control
1
operating mode".
Only available in the configuration variant "DQ 4x24VDC/2A HS V2.0, MCC (16 Byte) MtM".
2
Digital output module DQ 4x24VDC/2A HS (6ES7132-6BD20-0DA0)
Manual, 06/2018, A5E32855695-AC
Value range
1 to 64
1
DI 8x24VDC HS, Count, Ch.0
•
DI 8x24VDC HS, Count, Ch.1
•
DI 8x24VDC HS, Count, Ch.2
•
DI 8x24VDC HS, Count, Ch.3
•
AI 2xU/I 2-/4-wire HS, Ch.0
•
AI 2xU/I 2-/4-wire HS, Ch.1
•
AI 2xU/I 2-/4-wire HS, QI, Ch.0
•
AI 2xU/I 2-/4-wire HS, QI, Ch.1
•
TM Count 1x24VDC, Ch.0
•
TM Count 1x24VDC Fastmode, Ch.0
•
TM PosInput 1, Ch.0
• 2
TM PosInput 1 Fastmode, Ch.0
•
AI 2xSG 4-/6-wire HS, Ch.0
•
AI 2xSG 4-/6-wire HS, Ch.1
•
Default
1
1
DI 8x24VDC HS,
Count, Ch.0
2
2
2
Cam control operating mode
6.2 Parameters/address space
Configura- Effective range
tion with configuration
in RUN software
GSD file
PROFINET IO
No Module
No Module
No Module
73