Parameters - Siemens SIMATIC ET 200SP Manual

3.2.2

Parameters

DQ 4×24VDC/2A HS parameters
The effective range of the assignable parameters depends on the type of configuration.
The following configurations are possible:
● Central operation on an ET 200SP CPU or on an ET 200SP Open Controller
● Distributed operation on PROFINET IO in an ET 200SP system
● Distributed operation with PROFIBUS DP in an ET 200SP system
In addition to assigning parameters with the configuration software, you can also set the
parameters in RUN mode (dynamically) using the user program. When assigning the
parameters in the user program, the "WRREC" instruction transfers the parameters to the
module using data records; see section Parameter assignment and structure of the
parameter data record for DQ operating mode (Page 98).
The following parameter settings are possible:
Table 3- 1 Assignable parameters in DQ operating mode (valve control) (GSD file)
Parameter
Operating mode
4
Output rate
Diagnostics
No supply voltage L+
Diagnostics
Short circuit to L+/G
Channel activated
Reaction to
CPU STOP
Digital output module DQ 4x24VDC/2A HS (6ES7132-6BD20-0DA0)
Manual, 06/2018, A5E32855695-AC
Value range
Normal operation DQ
•
(valve control)
2
Oversampling
•
Pulse width modulation
•
Cam control
•
1 value/cycle
•
Disable
•
Enable
•
Disable
•
Enable
•
Disable
•
Enable
•
Shutdown
•
Keep last value
•
Output substitute value 1
•
DQ operating mode DQ (valve control)
Default Configura-
tion
in RUN
No
1 value/cycle No
Disable Yes
Disable Yes
Enable Yes
Shutdown Yes
3.2 Parameters/address space
3
Effective range with configura-
tion software
HSP0127 for GSD file
STEP 7 PROFIBUS
(TIA Portal); DP
HSP0230 for
STEP 7;
GSD file
PROFINET IO
Module Module
Module Module
Module Module
Module Module
Channel Channel
Channel Module
1
1
1
1
1
1
1
23