Oversampling Operating Mode; Connecting; Wiring And Block Diagram - Siemens SIMATIC ET 200SP Manual

Oversampling operating mode

4.1

Connecting

4.1.1

Wiring and block diagram

In this section, you can find the block diagram of the DQ 4x24VDC/2A HS module showing
the terminal assignments for a 2-wire and 3-wire connection in oversampling operating
mode.
You can find information on wiring the BaseUnit in the ET 200SP distributed I/O system
(https://support.industry.siemens.com/cs/ww/en/view/58649293) system manual.
Note
You can connect 2 actuators per output.
Note
Cross circuit at output
Be aware that voltage from a cross circuit at the output can feed L+ to modules.
Note
• The load group of the module must begin with a light BaseUnit. Keep this in mind also
during the configuration.
• The connection of actuators with 1-wire connection is not permitted.
Note
You may use and combine the different wiring options for all channels.
Note
Outputs DQ
Digital output module DQ 4x24VDC/2A HS (6ES7132-6BD20-0DA0)
Manual, 06/2018, A5E32855695-AC
- must not be connected with ground.
n
4
31