Explanation Of Parameters - Siemens SIMATIC ET 200SP Manual

Pulse width modulation operating mode
5.2 Parameters/address space
5.2.3

Explanation of parameters

Operating mode
At the module level, specifies the operating mode in which the module's channels are
operated. When configuring with HSP0230 for STEP 7 or with a GSD file, you determine the
operating mode when you select the module name.
● Normal operation as digital output module
– Valve control is a special function of normal operation, see section Normal
● Pulse width modulation, see section Pulse width modulation (Page 46)
● Oversampling, see section Oversampling (Page 34)
● Cam control, see section Cam control (Page 62)
Output rate
Specifies the number of subcycles per isochronous data cycle.
See section Oversampling (Page 34).
Diagnostics No supply voltage L+
Enabling of the diagnostics for no or insufficient supply voltage L+.
Diagnostics Short circuit to L+/G
Enabling of the diagnostics when a short-circuit of the actuator supply occurs.
Diagnostics Overflow
You use the "Diagnostics Overflow" parameter to enable the diagnostics for the case that the
permitted value range of the duty factor is exceeded, i.e. an output value > 1000 from the
user program is written to the output word of the channel. See section Pulse width
modulation (Page 46).
Channel activated
Specifies whether a channel is activated or deactivated.
Reaction to CPU STOP
Determines the behavior of the module in the event of a CPU STOP.
52
operation/Valve control (Page 21).
Digital output module DQ 4x24VDC/2A HS (6ES7132-6BD20-0DA0)
Manual, 06/2018, A5E32855695-AC