Vesa Mounting The Tlp 700Tv - Extron electronics TouchLink TLP 700MV User Manual

12.
13.
14.

VESA Mounting the TLP 700TV

Before attaching the VESA mounting kit, remove the base and back of the TLP 700TV, as
described in the previous section.
Once the base and back have been removed, the TLP 700TV can be VESA mounted using
either the Extron LPVM-1 or the Extron VM 700T mounting plate.
NOTE:
To VESA mount the TLP 700TV with the LPVM-1, follow the instructions provided with the
mounting kit. To mount the TLP 700TV with the VM 700T and a third-party VESA mounting
kit, follow the instructions provided with the VM 700T and the third-party kit.
Connect the video input, using the two BNC connectors (see
previous page).
When the base is attached the MTP input carries both audio and video signals. These
are split in the base and separate audio and video signals are sent to the touchpanel.
Once the base is removed, no audio input is available and an S-video or composite
video signal is input through the BNC connectors:
a. For S-video, connect the Y (luminance) signal to the VID/Y input (white cable) and
the C (chrominance) to the C input (yellow cable).
For composite video, connect the source to the VID/Y input (white cable).
b.
Connect the network cables to an Ethernet LAN using a twisted pair cable, terminated
with an RJ-45 connector (see
Replace the orange 2-pole captive screw connector on the provided power supply with
the blue connector from the power cable disconnected in step 11.
See figure 5 on page 6 for the wiring diagram.
ATTENTION:
The power supply provided with the TLP 700TV is intended for use with the
•
power input in the base. To use the power supply with the power input in the
rear panel, the captive screw connector must be replaced.
Le transformateur livré avec le TLP 700TV est prévu pour une utilisation avec
•
le connecteur d'alimentation située dans le socle. Afin de pouvoir utiliser la
source d'alimentation avec l'entrée d'alimentation sur le panneau arrière, le
connecteur sur vis captives doit être remplacé.
Do not connect any external power supplies until you have read the
•
Attention notifications in the Power Supply section
Ne branchez pas de sources d'alimentation externes avant d'avoir lu les
•
mises en garde dans la section « Power Supply »
If the VESA mounting kit is used, ensure all cables to the touchpanel are
•
correctly routed to avoid trapping them between the plates of the mounting
kit.
Si vous utilisez le kit de montage VESA, assurez-vous que tous les câbles
•
vers l'écran tactile soient routés correctement afin d'éviter de les coincer
entre les plaques et le kit de montage.
The Extron VM 700T is a mounting plate, which attaches to the back of the
TLP 700TV. It must be used together with a third party VESA mounting kit.
Network connector on page 8).
TLP 700MV and TLP 700TV • Mounting
figure 46, 5 , on the
(page 7).
(page 7).
41