Desktop Mounting The Tlp 700Tv; Removing The Tlp 700Tv Base For Vesa Mounting - Extron electronics TouchLink TLP 700MV User Manual

Desktop Mounting the TLP 700TV
The TLP 700TV comes assembled with a stand that allows it to be placed on a desktop.
If required, use two screws through the two holes in the base to secure the unit to the
desktop.
NOTE:
Adjustable
Potentiometers
Figure 38.
1.
2.

Removing the TLP 700TV Base for VESA Mounting

Extron provides two kits for wall mounting the TLP 700TV.
•
•
Use the three potentiometers
page 11) before securing the base to the desktop.
Base of TLP 700TV
Drill two holes through the desktop from underneath. The two holes must be 5.1 inches
(13 cm) apart.
Use two 8-32 wood screws through the desktop from underneath into the two holes in
the base.
Insert the power supply, the network, and twisted pair video cables to the connectors
on the back of the stand.
ATTENTION:
The left RJ-45 connector on the back of the TLP 700TV (with the yellow and
•
green LEDs) must be connected to a network.
Le connecteur RJ-45 gauche situé au dos du TLP 700TV (avec des LED
•
jaunes et vertes) doit être connecté à un réseau.
The right RJ-45 connector must be connected to an Extron MTP Transmitter.
•
Le connecteur RJ-45 droit doit être connecté à un émetteur MTP Extron.
•
The MTP and LAN use different voltages; switching the connectors will
•
damage the touchpanel.
Le MTP et le LAN utilisent des tensions différentes; permuter les connections
•
risque d'endommager l'écran tactile.
The VM 700T is an adapter that is used to mount the TLP 700TV to any third party
VESA D-type (75 x 75 mm) mounting kit.
The LPVM-1 is used to wall mount a monitor with either the B-type (20 x 50 mm) or the
D-type (75 x 75 mm) mounting patterns.
CAUTION: The maximum load for the LPVM-1:
VESA B or VESA D with mud ring— 4.4 pounds (2 kg)
•
VESA D if the LPVM-1 is mounted directly to a wall— 30.8 pounds (14 kg)
•
ATTENTION :
La charge maximum pour le LPVM-1:
VESA B ou VESA D avec un cadre d'installation— 2 kg (4,4 pounds)
•
VESA D si le LPVM-1 est monté directement de façon murale — 14 kg (30,8
•
pounds)
to adjust the sharpness and gain (see
Use two 8-32 screws
through these holes
to secure the base
to the desk top.
TLP 700MV and TLP 700TV • Mounting 36