Special points to be noted
• The tool type must be specified for each tool cutting edge.
• Only the values specified can be used for the tool type.
• Tool type "0" (zero) means that no valid tool has been defined.
Tool compensation data for slotting saw type
The following compensation data (TOA data) can be specified for the slotting saw tool type
(type 700):
Length compensation
Length 1
Length 2
Length 3
Saw blade compensation
Diameter d
Slot width b
Projection k
Figure 2-4
Basic logic functions: Tool Offset (W1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
Geometry
$TC_DP3
$TC_DP4
$TC_DP5
$TC_DP6
$TC_DP7
$TC_DP8
Geometry of slotting saw (analogous to angle head cutter)
Wear
Base
$TC_DP12
$TC_DP21
$TC_DP13
$TC_DP22
$TC_DP14
$TC_DP23
$TC_DP15
$TC_DP16
$TC_DP17
Detailed Description
2.3 Tool cutting edge
Einheit
mm
mm
mm
mm
mm
mm
39