Signals From Axis/Spindle (Db31; Velocities, Setpoint/Actual Value Systems, Closed-Loop Control (G2) - Siemens SINUMERIK 840D sl Function Manual

2.6.2

Signals from axis/spindle (DB31, ...)

DB31, ...
DBX62.4 Activate travel to fixed stop
Edge evaluation: no
Signal state 1 or The "Travel to fixed stop" function is active.
edge change
This signal is used for analog drives in order, for example, to activate the current or torque limitation
0 → 1
parameterized in the actuator.
Signal state 0 or The "Travel to fixed stop function" is not active.
edge change
1 → 0
DB31, ...
DBX62.5 Fixed stop reached
Edge evaluation: no
Signal state 1 or The fixed stop was reached after selecting the FXS function.
edge change
This signal is used by analog drives, e.g. to switch the actuator from speedcontrolled to current or
0 → 1
torquecontrolled mode so that a programmable clamping torque can be set.
Signal state 0 or The fixed stop has still not been reached after selecting the FXS function.
edge change
1 → 0
2.7

Velocities, Setpoint/Actual Value Systems, Closed-Loop Control (G2)

No signal descriptions required.
Basic logic functions: NC/PLC interface signals (Z1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
2.7 Velocities, Setpoint/Actual Value Systems, Closed-Loop Control (G2)
Signal(s) updated: cyclic
Signal(s) updated: cyclic
Detailed Description
73