Siemens SINUMERIK 840D sl Function Manual page 2094

Detailed Description
2.9 Mode group, channel, program operation, reset response (K1)
DB21, ...
DBX35.2
Program status stopped
Edge evaluation: no
Signal state 1 or The NC part program has been stopped by:
edge change
•
0 → 1
•
•
•
•
Signal state 0 or "Program status stopped" is not present.
edge change
1 → 0
Corresponds to .... DB21, ... DBX7.3 (NC stop)
DB21, ... DBX7.4 (NC stop, axes plus spindles)
DB21, ... DBX7.2 (NC stop at the block limit)
DB21, ...
DBX35.3 Program status interrupted
Edge evaluation: no
Signal state 1 or When the operating mode changes from AUTOMATIC or MDA (in stopped program status) to JOG,
edge change the program status changes to "Interrupted". The program can be continued at the point of
0 → 1 interruption in AUTOMATIC or MDA mode when NC start is issued.
Signal state 0 or "Program status aborted" is not present.
edge change
1 → 0
Special cases, The interface signal:
errors, ...... DB21, ... DBX35.3 (program status interrupted)
indicates that the part program can continue to be processed by restarting it.
DB21, ...
DBX35.4 Program status aborted
Edge evaluation: no
Signal state 1 or The program has been selected but not started, or the current program was aborted with a reset.
edge change
0 → 1
Signal state 0 or Program status interrupted is not active.
edge change
1 → 0
Corresponds to .... DB21, ... DBX7.7 (reset)
98
Signal(s) updated: cyclic
DB21, ... DBX7.3 (NC stop)
DB21, ... DBX7.4 (NC stop, axes plus spindles)
DB21, ... DBX7.2 (NC stop at the block limit)
Programmed M00 or M01
Or
Single block mode
Signal(s) updated: cyclic
Signal(s) updated: cyclic
Basic logic functions: NC/PLC interface signals (Z1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0