Siemens SINUMERIK 840D sl Function Manual page 1946

Detailed Description
2.9 Sum offsets and setup offsets
Type of action of the individual vectors
The type of action of the individual vectors or groups of vectors depends on the following
further quantities:
Influencing quantity
G codes
Tool type
Machine data
Setting data
Toolholder with orientation capability
Adapter transformations
Distribution over the geometry-axis components
How the three vector components of partial totals of the vectors involved are distributed over
the three geometry-axis components is determined by the following quantities:
Influencing quantity
Active processing level:
G17 X/Y direction
G18 Z/X direction
G19 Y/Z direction
Tool type:
Milling tools, drilling tools, grinding tools, turning tools
SD42900 $SC_MIRROR_TOOL_LENGTH
SD42910 $SC_MIRROR_TOOL_WEAR
SD42920 $SC_WEAR_SIGN_CUTPOS
SD42930 $SC_WEAR_SIGN
SD42940 $SC_TOOL_LENGTH_CONST
SD42950 $SC_TOOL_LENGTH_TYPE
Adapter transformations
The resulting tool orientation always remains parallel to one of the three axis directions X, Y
or Z and exclusively depends on the active machining plane G17-G19, since it has not yet
been possible to assign the tool an orientation.
158
Operating principle
Active processing level
Milling tool or turning/grinding tools
Tool management active/not active, toolholder with
orientation capability available/not available
Behavior of tool length components when mirroring or
when changing the plane
Set values of toolholder with orientation capability
Transformed tool compensation values
dependencies
Infeed plane:
Z
Y
X
See:
Section "Tool type", Table "Minimum
number of required tool parameters"
See:
Sections "Special handling of tool
compensations" and "Setting data".
See: "FB Tool management"
Basic logic functions: Tool Offset (W1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0