Siemens SINUMERIK 840D sl Function Manual page 1820

Detailed Description
2.2 Flat D number structure
Delete D no. via part program
• With flat D number
• Without flat D number
• $TC_DP1[0] = 0
Active compensation data blocks (D numbers) cannot be deleted. It may, therefore, be
necessary to program D0 before deleting.
Tool MDs
The following machine data affect the way tools and cutting edges (D numbers) work in the
NCK:
• MD20270 $MC_CUTTING_EDGE_DEFAULT (Basic setting of tool cutting edge without
• MD20130 $MC_CUTTING_EDGE_RESET_VALUE (tool cutting edge length compens.
• MD20120 $MC_TOOL_RESET_VALUE (tool cutting edge length compens. During ramp-
• MD20121 $MC_TOOL_PRESEL_RESET_VALUE (Preselected tool at RESET)
• MD22550 $MC_TOOL_CHANGE_MODE (new tool compensation with M function)
• MD22560 $MC_TOOL_CHANGE_M_CODE (M function for tool change)
• MD20110 $MC_RESET_MODE_MASK (Determination of control default settings after
• MD20112 $MC_START_MODE_MASK (Definition of the control default settings in case
2.2.4 Programming the T number
When the "Flat D number structure" function is active, NC address T continues to be
evaluated, i.e., the programmed T number and the active T number are displayed. However,
the NC determines the D number without reference to the programmed T value.
The NC detects 1 master spindle per channel (via the spindle number, which can be set
using MD). Compensations and the M6 command (tool change) are only calculated in
reference to the master spindle.
An address extension T is interpreted as a spindle number (e.g., T2 = 1; tool 1 to be selected
on spindle 2); a tool change is only detected if spindle 2 is the master spindle.
32
$TC_DP1[d] = 0
Compensation data set is deleted from NCK with number d.
The memory is then free for the definition of another D number.
$TC_DP1[t][d] = 0=
Cutting edge d of tool t is deleted.
Delete all D compensations from NCK.
programming)
During ramp-up)
up)
RESET/TP end)
of NC START)
Basic logic functions: Tool Offset (W1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0