Siemens SINUMERIK 840D sl Function Manual page 1935

Parameters for geometry and wear
Tool geometry compensations are assigned to system variables $TC_DP3 to $TC_DP11.
System variables $TC_DP12 to $TC_DP20 allow you to name a wear for each of these
parameters.
Geometry
$TC_DP3
$TC_DP4
$TC_DP5
Geometry
$TC_DP6
$TC_DP7
Geometry
$TC_DP8
$TC_DP9
$TC_DP10
$TC_DP11
Tool base dimension/adapter dimension
$TC_DP21
$TC_DP22
$TC_DP23
Technology
System variable
$TC_DP24
$TC_DP25
Basic logic functions: Tool Offset (W1)
Function Manual, 11/2006, 6FC5397-0BP10-2BA0
Wear Length compensations
$TC_DP12 Length 1
$TC_DP13 Length 2
$TC_DP14 Length 3
Wear Radius compensation
$TC_DP15 Radius
$TC_DP16 Corner radius (tool type 700; slotting saw)
Wear Further compensations
$TC_DP17 Length 4 (tool type 700; slotting saw)
$TC_DP18 Length 5
$TC_DP19 Angle 1 (angle between face of tool and torus surface)
$TC_DP20 Angle 2 (angle between tool longitudinal axis and upper
end of torus surface)
Adapter length 1
Adapter length 2
Adapter length 3
Clearance angle
The clearance angle is stored here for ManualTurn; tool type 5xx.
•
Same significance as in standard cycles for turning tools.
The tip angle of the drill is stored here for ShopMill; tool type 2xx.
•
Used in standard cycles for turning tools; tool type 5xx. This is the
•
angle at the secondary cutting edge for these tools.
The value for the cutting rate is stored here for ManualTurn.
•
A bitcoded value for various states of tool types 1xx and 2xx is stored
•
here for ShopMill.
Detailed Description
2.9 Sum offsets and setup offsets
147