Table of Contents
Advertisement
Chapter 8 Transferring the 2000 Platform Interface
Establishing connection
Establishing connection
Connecting the
2000 Platform
and the PC
Configuring the
2000 Platform
64
The connection between 2000 Platform and the PC can be done directly,
or via a local network.
The transfer of the interface can be done using a VNC window on PC.
For an intensive use of the deport screen or when it is used via a
WAN network, it is strongly recommended to use a dedicated
VNC client. The VNC clients recommended are Tight VNC (V 1.2.9
or later) and Real VNC (V 4.1.1 or later).
1
Connect the 2000 Platform to the PC via an Ethernet cable, using
the RJ45 connectors set on both equipments.
Fig. 38
Connection 2000 Platform and PC
2
Check the network connection on the PC is set in Dynamic mode.
1
In the Home page of the 2000 Platform, validate the Settings icon.
2
In the System Settings page, in the I/O Interfaces box, configure
the following parameters:
Ethernet > Mode
Parameters of the local Ethernet network to which the 2000 Platform is
connected:
Config 1 to 4
– Site Name
User Manual
790000002/00
static mode enabling input of the configuration of
4 sites. If this parameter is selected, the folowing
parameters must be entered:
the user can enter the name of the site in the Edit
menu.
Advertisement
Table of Contents
Troubleshooting
