Report; Fiber; Adding A New Profile - JDS Uniphase 2000 Platform User Manual

Chapter 6 Scope
Configuring the P5000 Scope

Report

Fiber

Adding a new
profile
38
The parameters in Report box allow to configure the Report page setup.
On the line Company, enter the name of your company using the edition
keypad.
On the line Logo, you can select an image on the 2000 Explorer once
clicking on the right arrow key, which will be displayed on the upper left
part of the report. Press the
On the line Operator, you can enter the name of the operator, which will
be displayed on the header of the report.
See Figure 22 on page 44
The Fiber box allows to configure the fiber plugged to the scope.
On the line Fiber Name, use the edition keypad, which will display by
clicking on the right arrow key, to enter a specific name for the fiber.
On the line Fiber Number, use the numeric keypad, which will display by
clicking on the right arrow key, to enter the fiber number.
Press Exit to return to the Results screen of the scope.
Once the Setup screen of the scope is displayed, you can add a specific
profile which will be used for the test.
The profile must be created via FiberChek2
storage media of the MTS/T-BERD 2000 (disk, or USB memory stick).
1 On the Setup screen, select Profile and press Add key.
2 On the explorer, select the file which will be used as profile (icon
; extension: .PRO)
3 Press Load.
Once loaded, the display goes back automatically to Setup screen.
4 Select the profile just loaded.
Removing a profile
1 In the Profile list, select the profile to be deleted.
2 Press Remove key., then Exit.
User Manual 790000002/00
S
key to return back to the Setup page.
ETUP
for a description of the pdf report.
TM
, and stored on one