Talkset Function; Talkset Configuration; Connections; Establishing Communication - JDS Uniphase 2000 Platform User Manual

Talkset Function

n
Talkset
configuration

Connections

Establishing
communication
Chapter 5 Power meter, VFL (Visual Fault Locator) & Talkset
The Talkset option enables two operators at opposite ends of an optical
link to communicate along the fiber. Each end of the optical link must be
provided with a 2000 Platform equipped with the Talkset option.
NOTE
It is possible to use the talkset of the 2000 Platform and to carry out
measurements at the same time, on a different fiber.
The talkset configuration is set in the System Settings screen, in the
Channel box (see "Defining the Audio parameters of the 2000 Platform"
page 24)
At each end of the fiber:
1 Connect the fiber to the Talkset port of the 2000 Platform, either
directly or through jumpers.
JDSU recommends you to use the following connections:
- PC Fiber Connection (APC is not recommended)
- SC or FC connection (UPP is supplied but not recommended).
Fig. 15 Installation for Talkset use
2 A headset (with earphones and a microphone) supplied with the
option may also be plugged into the 2000 Audio jack.
On the caller 2000 Platform, press the
Talkset option:
User Manual 790000002/00

Talkset Function

H
button, then validate the
OME
33