Table of Contents
Advertisement
Chapter 3 Starting up
Fitting and removing a module
Fitting and removing a module
Fitting a
module
1a
1b
Removing a
module
14
The 2000 Platform must be switched off, and if it is operating on
the mains, its supply cable must be unplugged.
1
Turn the instrument face down on the work surface.
2
Set the two notches on the module part (1a) into the two holes
provided for that purpose on the Base (1b).
3
Make flush the 2 connections (2a & 2b), on module and base.
4
Once positioned, fix the module to the base screwing the 2 screws
(3a) fixing the receptacle.
3a
1a
1b
Fig. 6
Fixing the module to the base
1
Unscrew the two captive fixing screws of the module completely (up
to the stop).
2
Remove the two slots of the module from their housing onto the
base.
3
Carefully remove the module out of its slot.
User Manual
790000002/00
3a
2a
2b
Advertisement
Table of Contents
Troubleshooting
