Freeze Mode; Camera Mode; Launching A Test Of The Connector And Fiber End-Face - JDS Uniphase 2000 Platform User Manual

Chapter 6 Scope

Launching a test of the connector and fiber end-face

Freeze mode

Camera mode

Launching a test of the connector and fiber end-face

Launching a
test of the
connector and
fiber end-face
40
Once the image is acceptable (sharpness, luminosity and contrast are
tuned correctly), you may
in memory the resulting picture.
Freezing a scope result does not store the picture in a file (see
menu" page 43). The result will be lost if the instrument is shut off, or if
more than 3 pictures are frozen (see
NOTE
The button set on the lead, or the QuickCapture™ on the P5000
allows to freeze the picture or to take a snapshot.
Adding a comment
A key Comment allows you to enter/modify a comment to your picture if
necessary. This comment appears at the bottom left of the picture.
The right bottom of the frozen picture also contains the date of the acqui-
sition (where the picture was frozen).
NOTE
Both the comment and the date will be saved with the picture.
Set the key Camera/Freeze
result.
Use the focus control to adjust the focus of the image
Once the Brightness and Contrast parameters are correctly defined for
the current image (see
test of fiber connector can be launched.
The High mag./Low mag. key allows to display the picture with a high
or low magnitude.
To launch the test:
1 Press Test key to launch the test of plugged fiber connector.
User Manual 790000002/00
freeze the picture. This feature allows to store
"Mosaic Mode" page
on Camera, to get a live picture of the scope
"Luminosity and Contrast settings" page
"File
42).
39), a