Table of Contents
Advertisement
Chapter 11 Maintenance and Troubleshooting
Maintenance procedure
Installation from
Ethernet
86
H
6
Press the
OME
Tools > Upgrades > Software Upgrade > Upgrade from
The message Are you sure? is displayed
7
Click on Confirm.
The list of the software versions available on the USB stick is
displayed next to the versions installed on the 2000 Platform.
8
Click on Show
previous and next versions available.
9
Click on
Confirm this Choice
software(s).
or
Click on Confirm All Choices to upgrade all versions.
NOTE
The software versions list does not always appear (cf previous ver-
sions) as well as the
firm/Continue
key. In this case, the upgrading starts automatically.
Upgrading begins. The 2000 Platform is automatically rebooted.
Upgrading takes several minutes. Finally, the 2000 Platform is auto-
matically restarted.
During the upgrade, the Testing indicator is lit in red. Do not
push any button or remove the USB memory stick while the
indicator is lit. The USB stick can be removed if necessary once
the Testing indicator is off.
Before starting the software upgrade via Ethernet, make sure the IP
adress of the PC server.
The update can be performed directly onto the equipment, using an http
address.
1
Connect the 2000 Platform to a PC via an Ethernet link.
2
On the Home page, press Settings key to open the System
Settings page.
3
In I/O Interfaces, on the line Ethernet, select Mode: Dynamic.
4
In the Upgrade Server box:
–
On the line Address Type, select Server name
–
On the line Server Name, enter the address:
2k.updatemyunit.net
User Manual
790000002/00
button, then successively the
Prev choice
or Show
to start the upgrade of the selected
Previous / Next Choice
Settings > Expert
Next Choice
to display the
buttons and the
USB.
Con-
Advertisement
Table of Contents
Troubleshooting
