Commands Of The Power Meter Parameters - JDS Uniphase 2000 Platform User Manual

Commands of the
power meter
parameters
Chapter 5 Power meter, VFL (Visual Fault Locator) & Talkset
direction key . The table shows the power measured in dBm, the rela-
tive power (in dB) and the reference level in dBm (if units = dB), together
with the mode.
– A measurement result is displayed in the table when the
Result softkey is pressed.
– The Clear Table
in the table.
– If the Alarm function has been activated, any result that exceeds the
selected thresholds appears in red in the table. Otherwise, results
are shown in the table in green.
– When the instrument is switched off, results present in the table are
saved.
Results
of the
power meter
Fig. 14 Results and commands of the power meter
When the LTS function is selected, the following softkeys are available
on the results page:
Keep Result
Clear Table
Pressing the Powermeter Config. key allows to reach the following
function:
Wavelength
Unit
Zero
Click on Exit to go back to the Results page.
Pressing the Pow. Reference key allows to reach the following function:
User Manual 790000002/00
softkey orders deletion of all the results displayed
Saves the result on the corresponding line of the
table.
Deletes all the results recorded in the table.
Allows to modify the wavelength to be applied
with the Power meter.
Allows to modify the unit of power displayed (dB,
dBm, nW)
Adjustment of the Zero value when the power
meter's optical input is closed with a plug (a
validation is required).
Using the Power meter
Keep
29