Trace Window - Renesas M34286T2-CPE User Manual

M34286T2-CPE User's Manual

3.4 Trace Window

(1) Trace window
1) Trace window
Menu Menu item
Window Trace Window
R20UT0214EJ0200 Rev.2.00
Sep 16, 2010
Opens the trace window.
Trace window
The trace window is used to show the results of
real-time trace measurements. It has the following
three display modes:
- Bus mode (BUS)
Bus information per cycle can be inspected. The
contents are displayed in order of execution
paths.
- Disassemble mode (DIS)
The execution paths of the executed instructions
can be inspected. The contents are displayed in
order of execution paths.
- Source mode (SRC)
The execution paths of the source program can
be inspected.
These modes can be switched over using the
respective toolbar buttons.
The trace window shows the measurement result
when a real-time trace measurement has finished.
The trace window remains blank until the
real-time trace measurement in progress finishes.
3. Usage (How to Use the Emulator Debugger)
Function
Page 47 of 70