Charging The Battery; Charging Process; Charging Times - Otto Bock DynamicArm 12K100N Instructions For Use Manual

Hide thumbs Also See for DynamicArm 12K100N:
Table of Contents

Advertisement

Handling
7 Handling

7.1 Charging the battery

The product is powered by an integrated high-quality Li-Ion battery with sufficient capacity to operate for one full
day of usual everyday activities. Turning the product off during longer periods of passive use (e.g. air or rail travel,
visit to a theatre or cinema, etc.) will make the battery last longer. We recommend charging the product once a day
when used by the patient on a daily basis. Electronic battery management provides the patient with information
about the battery charge level (battery management).
The charging unit consists of the charging plug and the power cord. The battery charger has an input voltage
range of 100–240 V and may be operated in a mains frequency range of 50–60 Hz.
INFORMATION
Please note the corresponding instructions for use of the battery charger.

7.1.1 Charging process

WARNING
Charging the prosthesis without taking it off
Risk of electric shock due to defects in the power supply unit or in the battery charger.
► For safety reasons, remove the prosthesis prior to charging it.

7.1.2 Charging times

Charging time
3 hours
1.5 hours
20
2) Install the plastic screw to secure the two connect­
3) Push the coaxial plug in to the stop and rotate it
4) Install the coaxial plug in the lamination ring.
1. Extend and switch off the product.
2. Lock the product with the pull cable.
3. Take off the elbow joint.
4. Connect the power cord to the battery charger.
5. Insert the charging plug into the charging recept­
6. Plug the power cord into a wall socket. If the LED
7. If the LED shows a green light after charging, this
8. Disconnect the power cord of the battery charger
Capacity
100%
80%
ors.
until the stop noticeably engages.
acle (see figure).
Do not force it in!
shows an orange light, the battery is charging.
If the LED shows a green light but the battery is
drained, the charging plug was not inserted cor­
rectly.
indicates that the battery is fully charged.
from the wall socket.
Operating time
approx. 18 hours
approx. 14 hours
DynamicArm 12K100N

Advertisement

Table of Contents
loading

Table of Contents