Assembling The Housing - Otto Bock DynamicArm 12K100N Instructions For Use Manual

6.6 Assembling the housing

DynamicArm 12K100N
2) Connect the cables.
3) Thoroughly seal the plug and blanking covers from
above with 633F11 silicone grease.
1) Slide the electrode housing with the connected
cables into the greased lamination ring. It has to
engage completely!
2) The circuit board and the edge of the lamination
ring must be parallel to each other.
3) The electrode housing has engaged properly. The
circuit board and the edge of the lamination ring are
parallel to each other.
Preparation for use
15