Platform - Zepro Z 2500-130 Series Installation Instructions Manual

Installation
6.13

Platform

1. Check that all included components are clean,
cleaning them where necessary.
2. Lubricate the metal bushings on the upper bearing
of the arms. Ensure that the small holes on the
inside of the bushings are filled with grease. See
illustration. Use Zepro lubricant or the equivalent.
NOTE.
Carefully lubricate the metal bushings on the
upper bearing of the arms. Ensure that the small
holes are filled with grease. After the platform is
fitted, lubricate all bearings via normal grease
nipples, see section "15 Lubrication and fluid
level check" on page 71.
3. Fit the platform to the arms using the supplied
shafts and screws. Tighten the bolts using a
torque wrench. Tightening torque: 80 Nm.
4. Fit one of the tilt cylinders to the platform.
Use the supplied shaft and support wheel.
NOTE.
Make sure the cylinders are installed with the
grease nipples facing up.
Tighten the bolts using a torque wrench.
Tightening torque: 80 Nm.
30
NOTE! Lubricate the bushings
Image 45. Carefully lubricate the metal bushings
Image 46. Fitting the platform to the arms
Image 47. Fitting the tilt cylinder to the platform
Z 2500-130/150
www.zepro.com