Installing The Platform - Zepro ZHZ 500 Installation Instruction

ZHZ 500/600-850
Installation
5.2

Installing the Platform

1. Remove the cover at the lower en of the platform, see Fig 10.
2. Push the shaft out off the platform, see Fig 11.
3. Position the platform on the lift arms, see Fig 12.
4. Push the shaft inwards until its flush with the platforms suface on the opposite side,
see Fig 13:1.
5. Fit in the screw (attached), see Fig 13:2, to lock the platform shaft.
6. Refit the cover.
7. Attach the cylinder to the cylinder bracket and lock with locking pin, see Fig 14.
Fig 10. Remove the cover
Fig 12. Place the platform
Fig 11. Push the shaft out off the platform
2
1
Fig 14. Attach and lock the cylinder
Fig 13. Fit in and lock the platform shaft
14
www.zepro.com