Table of Contents
Advertisement
Installation
When installing on chassis with pre-drilled holes
16. Bolt the brackets securely on the outside of the
vehicle chassis. Install in the slot-shaped holes
with at least 6 screws. Use suitable bolts (durabil-
ity equivalent to M14 10.9 or higher) and install
the associated washer and nut on the inside of the
vehicle chassis. Install the bolts but do not tighten.
See Image 17.
17. Check and perform fine adjustment regarding the
position of the lift. Then tighten the bolts with a
torque wrench. Tightening torque: Standard for
selected screw.
18. Using a torque wrench, tighten the bolts holding the
U-profiles. Tightening torque: 280 Nm.
19. Drill holes in the vehicle chassis for mounting bolts
in each bracket's two upper round holes. Use
suitable bolts (durability equivalent to M14 10.9 or
higher) and install the associated washer and nut
on the inside of the vehicle chassis. See Image 17.
Tighten the bolts with a torque wrench. Tightening
torque: Standard for selected screw.
NOTE.
Welding is not permitted on the chassis brackets.
Do not move the lift all the way to the armstops or
with the platform fitted before all the bolts are fully
tightened against the chassis.
Do not place the lift under load until:
·
the correct number of bolts have been installed
and torque-tightened.
·
the vehicle body is installed to reinforce the
truck chassis.
20. Remove the mounting jig.
18
Image 17. Installing the chassis bracket on ve-
hicle chassis with pre-drilled holes
Z 2500-130/150
www.zepro.com
Hide quick links:
Advertisement
Table of Contents
