Zepro Z 2500-130 Series Installation Instructions Manual page 35

Installation
6.13.3 Adjusting the downward tilt angle
NOTE.
The tilt angle must be set at 90° to the vehicle body
before the downward tilt angle is adjusted (see
previous page).
m
WARNING!
To ensure that the lift is safe and CE compliant, the
downward tilt angle must be adjusted to max. 10° if
there are going to be people on the platform.
1. Raise the lift to the vehicle floor. Image 6045.
2. Loosen the lock screw of the end stop (2). Screw
the end stop all the way back towards the platform
(3). Image 61.
3. Tilt the platform down to max. 10° below the hori-
zontal. Image 60.
4. Adjust the end stop all the way to the top of the
cylinder (4). Image 61.
5. Tighten the lock screw in the end stop (5). See
illustration. Image 61.
The tightening torque for lock screws is between 3-5 Nm
Test all functions.
www.zepro.com
Adjusting collar
Lock screw
Bolt
Washer
Image 62. Tilt cylinder
Image 60. The tilt angle must be ad-
justed to max.10° down
2
5
3
4
Image 61. End stop with lock screw
End stop
Z 2500-130/150
35