Table of Contents
Advertisement
Installation
4.2
Platform
1. Check that all included components are clean,
cleaning them where necessary.
2. Lubricate the metal bushings on the upper bear-
ing of the arms. Ensure that the small holes on
the inside of the bushings are filled with grease.
See illustration. Use LE lubricant 4622 or the
equivalent.
IMPORTANT!
Carefully lubricate the metal bushings on the upper
bearing of the arms. Ensure that the small holes
are filled with grease. After the platform is fitted, lu-
bricate all bearings via normal grease nipples, see
"9 Lubrication and fluid level check" on page 55.
3. Fit the platform to the arms using the supplied
bolts. Tighten the bolts using a torque wrench.
Tightening torque: 80 Nm.
4. Fit one of the tilt cylinders to the platform. Use
the supplied bolt and support wheel.
IMPORTANT!
Make sure the cylinders are installed with the
grease nipples facing up.
Tighten the bolt using a torque wrench.
Tightening torque: 80 Nm.
www.zepro.com
ZAHD, ZAEHD 150/200-155/175
NOTE! Lubricate the bushings
Image 29. Carefully lubricate the metal bushings
Image 30. Fitting the platform to the arms
Image 31. Fitting the tilt cylinder to the platform
23
Advertisement
Table of Contents
