Calculating The Installed Dimensions; C Dimension; D Dimension; A Dimension - Zepro Z 2500-130 Series Installation Instructions Manual

Calculating the installed dimensions
4

Calculating the installed dimensions

For easier installation it is useful to calculate and specify the necessary dimensions in advance. Determine the
C dimension first, then obtain the other dimensions from the relevant table. You should try to place the lift as
high as possible within the specified C dimension in the table.
4.1

C dimension

The C dimension is the distance between the top of the support frame and the vehicle floor level. This dimen-
sion governs how far the lift needs to be installed under the vehicle body (D dimension) and the space there
will be between the lift arms in the upper position and the vehicle floor level (A dimension).
4.2

D dimension

The D dimension is the space the lift needs, measured from the rear edge of the body to the front edge of the
support frame (in the direction of the vehicle). Once the C dimension is determined, the D dimension can be
obtained from the table.
4.3

A dimension

The A dimension is the space provided for the rear beam, i.e. the space there will be between the lift arms and
the vehicle floor with the lift in the raised position. The A dimension depends on the C dimension.
4.4

H dimension

The H dimension is the height from the ground (unloaded) to the vehicle floor level. The H dimension must not
be greater that the maximum lifting height of the lift. The platform must always be able to reach ground level.
www.zepro.com
Z 2500-130/150
13