Transport Plug; Moving Parts - Free Movement - Zepro Z 2500-130 Series Installation Instructions Manual

Safety rules
2.2

Transport plug

NOTE.
When the lift is installed, the transport plug in the
hydraulic unit must be removed and replaced with
the normal tank cap supplied with the hydraulic
unit.
2.3

Moving parts - free movement

m
WARNING!
When the final inspection* takes place, the space
occupied by the moving cylinders must be cleared
and made safe. There is a risk of collision between
the cylinder and the following items: subframe, truck
chassis, beam for rear light (number plate) and the
chassis bracket of the lift (with a short overhang).
*The final inspection must be carried out with the
platform flat and tilted down 10°. The clearance
from the closest part of the cylinder must be at
least 40 mm.
m
WARNING!
The platform must not be tilted down more than
10° from the horizontal.
10
54853
Image 4. Replace the transport plug with
the normal tank cap
Image 5. Clearance to the closest part of
the cylinder must be at least 40 mm
Image 6. The platform must not be tilted
down more than 10° from the horizontal
Z 2500-130/150
10º
10º
www.zepro.com