Table of Contents
Advertisement
Introduction
Z 2500-130/150
1.3
CE marking
Z-Lyften tail lifts on sale on the European market have been CE marked (CE stands for Conformité Européenne)
since 1/1/1995. The manufacturer guarantees that the product complies with the EU Machinery Directive.
The aim of the Machinery Directive is to increase the safety of products throughout Europe.
There are some basic general rules that must be followed before Z-Lyften products are installed.
Follow the installation instructions. If it is not possible to follow the installation instructions or if changes must
be made, the changes must be approved by the manufacturer. This is a consequence of CE marking rules. The
manufacturer is unable to certify compliance with the Machinery Directive if the product is subsequently changed
without its knowledge or approval. To retain a valid CE marking for the product, it is essential to contact Z-Lyften.
Welding is not necessary except where recommended by the manufacturer.
To improve safety we supply decals for the lift that are easy to understand regardless of the language. Make
sure these decals are attached so that the information they contain can be seen by the lift operator.
Position control devices so that the operator is in the safest possible location and has a clear view of the load,
the tail lift and the surrounding area. Follow the driver's instruction manual when using the control device and
its functions.
www.zepro.com
7
Hide quick links:
Advertisement
Table of Contents
