Zepro Z 2500-130 Series Installation Instructions Manual page 32

Installation
4. Turn the adjusting collar so that the platform just
meets the seal on the vehicle body.
5. Loosen the three lock screws on the other tilt cyl-
inder. See Image 52.
6. Turn the adjusting collar so that the tilt cylinder aligns
with the attachment on the platform. See Image 52.
m
WARNING!
The max. length of both cylinders must be adjusted
equally to avoid unwanted breakout forces.
7. Fit the other tilt cylinder to the platform mount-
ing. Use the supplied shaft and support wheel.
NOTE.
Make sure the cylinders are installed with the grease
nipples facing up.
8. Tighten the bolts using a torque wrench.
Tightening torque: 80 Nm.
9. Adjust the two cylinders alternately so that the
platform meets the vehicle body, see Image 51 (B).
32
Image 51. Adjusting the fit with the vehicle body.
Out
In
Image 52. Adjusting the tilt angle
Image 53. Fitting the tilt cylinder to the platform
Z 2500-130/150
Lock screws, 3 pcs.
www.zepro.com