Zepro Z 2500-130 Series Installation Instructions Manual page 64

Connection unit
Example of sequence of information codes:
Configuration 1
Example of sequence with sensor indication:
Sensor indication: C, Detected sensor: Di1
Example of sequence with control device indication:
Control device: 2, Detected button: B
13.2.2 Fault codes
If a fault arises, the fault code is shown in the display in the form of a letter for identifying the fault, followed by
numbers and/or number segments for further information, followed by sensor indication (C) in accordance with
the previous page.
In fault codes E, F and U, the numbers (1-9) show which control device/output the fault code refers to.
1. Fixed control device 1, including two-hand button 2h1
2. Fixed control device 2, including two-hand button 2h2
3. Radio control device, External
4. Coil control device
5. Truck slider control device
6. Radio control device, internal module
7. CS (cabin switch)
8. Control Power
9. Sensor Power
If the system discovers several faults, only the fault code for the fault with the highest priority will be shown auto-
matically. The display is prioritised in the order in the table below, L/H, E, F, U and A. To see all faults, press and
hold in button C on the control device. The system will then browse through the list so that all faults detected by the
system can be seen.
When the CS is switched off, the system will browse through a list containing the five most recent faults detected
before the display goes off.
64
Voltage detected 12V
Z 2500-130/150
Firmware 9.0
www.zepro.com