Zepro Z 2500-130 Series Installation Instructions Manual page 34

Installation
6.13.2 Installing angle sensor/Inclinometer
1. Screw together the angle sensor/Inclinometer and the mounting using the included screws, nuts and
washers, see Image 56 and Image 57.
NOTE!
The angle sensor must be installed with the cable in place according toImage 56.
2. Install the angle sensor/Inclinometern on the platform using the included screws, nuts and washers and
secure the cable with cable ties, see Image 58 and Image 59.
Image 56. Angle sensor and mounting
x1
Image 58. Installing the angle sensor
34
x4
Image 57. Inclinometer and mounting
x4
Image 59. Installing the Inclinometer
Z 2500-130/150
www.zepro.com