Table 5-5 Edit Profile Prompts - Honeywell VPR100 User Manual

Setpoint Profiler
Prompt
RAMP TYPE
TIME UNITS
EDIT SEGMENTS
GUAR SOAK LO LIM
GUAR SOAK HI LIM
HYSTERESIS
BATCH FIRST
SEGMENT
BATCH LAST
SEGMENT
204

Table 5-5 Edit Profile Prompts

Range/Selections
VAL/DUR, TIME, RATE,
EXTERNAL
SECS, MINS, HOURS
OFF or number
OFF or number
OFF or number
0-63
0-63
VPR & VRX – User Manual
Definition
See 4 types of ramp segments on page 186.
Select the time units to be used by all segments
of the profile.
See Table 5-6.
The profiler will Hold if PV #1 or PV #2 deviates
more than this much below the profiler output.
See Guaranteed Soak on page 191 for details.
The profiler will Hold if PV #1 or PV #2 deviates
more than this much above the profiler output.
See Guaranteed Soak on page 191 for details.
See Hysteresis on page 191 for details.
Specify the first segment of the batch phase.
Prior segments are the start-up phase. A value
of 0 indicates a single phase profile. See Two
types of profiles on page 185 for details.
Specify the last segment of the batch phase.
Segments after this segment are the shutdown
phase. A value of 0 indicates a single phase
profile. See Two types of profiles on page 185
for details.
(continued)
12/00