Table 5-3 Program Profiler Prompts - Honeywell VPR100 User Manual

Prompt
DISPLAY LO LIM
DISPLAY HI LIM
PV #1
PV #2
START
RESET/RUN
HOLD
ADVANCE
HOT START
FAST FORWARD
SHUTDOWN
RAMP INCREMENT
GUARANTEED SOAK
HOLD LEVEL/EDGE
12/00

Table 5-3 Program Profiler Prompts

Range/Selections
OFF or number
OFF or number
OFF, analog parameter, number
OFF, analog parameter, number
Discrete parameter, 1, 0, or OFF
Discrete parameter, 1, 0, or OFF
Discrete parameter, 1, 0, or OFF
Discrete parameter, 1, 0, or OFF
Discrete parameter, 1, 0, or OFF
Discrete parameter, 1, 0, or OFF
Discrete parameter, 1, 0, or OFF
Discrete parameter, 1, 0, or OFF
Discrete parameter, 1, 0, or OFF
LEVEL or EDGE
VPR & VRX – User Manual
Definition
Enter the lower limit for the SP Trend
display. Allow for the maximum and
minimum Profiler and PV values.
Enter the upper limit for the SP Trend
display, allowing for the maximum and
minimum Profiler and PV values.
Program the profiler to monitor a process
variable. PV #1 is trended on the SP
Trend display. PV #1 is compared to the
profiler's value to determine deviation.
Excessive deviation between PV #1 and
profiler value can cause a Hold
(guaranteed soak).
This is an optional PV that can also be
monitored and can be used to determine
deviation from profiler value. PV #2 is
shown on SP Trend display's Point/Detail
menu. PV #2 is also trended on SP Trend
display.
See Start on page 195.
See Reset/Run on page 195.
See Hold on page 196.
See Advance on page 196.
See Hot Start on page 196.
See Fast Forward on page 197.
See Shutdown on page 198.
See External Ramp Type on page 190.
See Guaranteed Soak on page 191.
Select LEVEL to Hold the profiler while
the Hold discrete is Level ON, and resume
Run when the Hold discrete is Level OFF.
Select EDGE to Hold the profiler after the
Hold discrete changes from OFF to ON,
and resume Run after the Start discrete
changes from OFF to ON.
Setpoint Profiler
201