Error Messages; Table 10-1 Error Messages - Honeywell VPR100 User Manual

Overview
Sometimes errors occur while you are programming or loading a configuration into your instrument. In
most cases the instrument displays a descriptive error message. For example, if you try to program a
function block incorrectly, the instrument tells you the problem.
Table 10-1 lists these error message along with a description of each one and what action to take.
Error
Block Phase Greater
Than Block Period
Channel Does Not Exist
Circuit Limits Equal
Condition Type Out of
Range
Desired F0 Value Not
Programmed or Less
Than Zero
High Limit Outside of
circuit.
High Output Limit
Greater than 20
High Output Limit
Greater Than 5
Hysteresis Less Than
Zero
Impulse Time less than
or Equal to 0
Incompatible Curve Type
12/00

10. Error Messages

Table 10-1 Error Messages

Description
In Periodic Timer CV, the phase (start time) is
greater than the period. For example, the start
time is 8:00 and the period is 4:00.
A channel was loaded that does not exist. For
example, you loaded a dual loop configuration
into a single loop instrument.
Indirect circuit low/circuit high limits must be
unequal.
Condition Type (Compare, Logic, Free form
Logic) is out of range. Probably caused by
someone incorrectly editing the configuration
file or by a corrupt .LNC file.
In the F Sterilization CV, desired F
0
programmed or is less than zero.
AI circuit high limit is > voltage limit of 5200 mV.
A current output (CAT) high output limit cannot
be greater than 20
A voltage output (VAT) high output limit must
not be greater than 5
Alarm Hysteresis parameter should be greater
than or equal to zero.
Impulse time on a time proportioning/duration
adjusting output (DAT) output cannot be less
than or equal to zero.
AI is custom type, thermocouple class,
reference junction enabled but Y values are not
always increasing or not always decreasing.
VPR & VRX – User Manual
Change Period to greater than phase
(Start Time) or change Start Time to
less than Period.
Verify programming of affected
function block.
Change to unequal limits.
Verify programming of affected
function block.
is not Change F value to greater than zero.
0 0
Change limit to within specified limits
for that type
Decrease high limit
Decrease high limit
Increase Hysteresis.
Increase impulse time
Reprogram curve so that for all n:
Y > Y or Y
n n+1
Error Messages
User Action
< Y
n n+1
277