Siemens SINAMICS S150 NEMA Operating Instructions Manual page 41

Mechanical installation
3.1 Content of this chapter
This chapter provides information on the following:
● The conditions for transporting, storing, and installing the enclosed drives
● Preparing and installing the drives
3.2 Transportation and storage
Transport
Incorrectly transporting the device
The device can tip over if you transport it incorrectly or if you use non-approved transport
equipment. Death, serious injury, and property damage can result.
• Ensure that only trained personnel transport the device with approved transport
• Comply with the information regarding the center of gravity. A label or stamp with exact
• Transport the unit only in the original marked upright position. Do not tilt the device.
• The forks of the forklift must protrude from the rear of the transport pallet. The floor
Using forklift trucks that are not approved
If the forks are too short, this can cause the transport unit/cabinet to tip over resulting in
death, serious injury, or damage to the cabinet.
• The forks of the forklift must protrude from the rear of the transport pallet. The floor
• Transport the units only with forklifts approved for this purpose.
Converter cabinet units
Operating Instructions, 11/2017, A5E36652151A
WARNING
equipment and lifting tools.
information regarding the center of gravity of the cabinet is attached to each transport
unit.
panels of the transport units do not support loading.
WARNING
panels of the transport units do not support loading.
3
39