Siemens SINAMICS S150 NEMA Operating Instructions Manual page 260

Commissioning
5.5 Initial commissioning with the AOP30
Resetting parameters via STARTER
With STARTER, parameters are reset in online mode. The required steps are described
below:
Step
Choose
Project > Connect to target system
Click the drive unit whose parameters you want to reset to the factory settings
and click the Restore factory settings button on the toolbar.
To confirm, click OK.
Choose
Target system > Copy RAM to ROM
Note
Copy RAM to ROM
The Copy RAM to ROM button is only active when the drive unit is selected in the project
navigator.
After a reset of parameters to factory settings, an initial commissioning must be performed.
258
Toolbar selection
Converter cabinet units
Operating Instructions, 11/2017, A5E36652151A