Table of Contents
Advertisement
Electrical installation
4.8 Signal connections
Shield connection
The shield connection of shielded control cables on the customer terminal module (-A60 or
-X65) is established in the immediate vicinity of the terminal module. For this purpose, the
customer terminal module –A60 and the mounting plates have cut-out sections which are
used to snap the enclosed shield springs into place. The shields of incoming and outgoing
cables must be applied directly to these shield connections. It is important here to establish
the greatest possible area of contact and a good conductive connection.
Note
Shield springs
These shield springs can be used for all control cables in the enclosed drive because all the
shield connections are identical in design.
Figure 4-17
98
Shield connection
Converter cabinet units
Operating Instructions, 11/2017, A5E36652151A
Advertisement
Table of Contents
