Siemens SINAMICS S150 NEMA Operating Instructions Manual page 331

Error Meaning
value
0x7C Parameter %s [%s]: write access only
in the commissioning state, device
download (device: p0009 = 29).
0x7D Parameter %s [%s]: write access only
in the commissioning state, device
parameter reset
(device: p0009 = 30).
0x7E Parameter %s [%s]: write access only
in the commissioning state, device
ready (device: p0009 = 0).
0x7F Parameter %s [%s]: write access only
in the commissioning state, device
(device: p0009 not equal to 0).
0x81 Parameter %s [%s] must not be
written during download.
0x82 Transfer of master control is blocked
by BI: p0806.
0x83 Parameter %s [%s]: requested BICO
interconnection not possible.
0x84 Parameter %s [%s]: parameter
change inhibited (refer to p0300,
p0400, p0922)
0x85 Parameter %s [%s]: access method
not defined.
0x87 Write job will not be executed.
0xC8 Below currently valid limit.
0xC9 Above currently valid limit.
0xCC Write access not permitted.
Converter cabinet units
Operating Instructions, 11/2017, A5E36652151A
6.7 Communication according to PROFIdrive
Comments
–
–
–
–
–
–
BICO output does not supply float values. The BICO input,
however, requires a float value.
–
–
The write job is rejected because know-how protection is
active.
Modification request for a value that, although within
"absolute" limits, is below the currently valid lower limit.
Modification request for a value that, although within
"absolute" limits, is above the currently valid upper limit
(e.g., governed by the current converter rating).
Write access is not permitted because an access key is
not available.
Operation
Additional
info
–
–
–
–
–
–
–
–
–
–
–
–
–
329