Table of Contents
Advertisement
• Stop
Function: Specify the trigger condition that must be met in order to stop measurement.
Off: No trigger is used. Instead, measurement is stopped by pressing the START/
STOP key.
Amp: Measurement is stopped when the level trigger condition is satisfied.
Note: See the CHECKPOINT on page 3-19 for more details on the Level Trigger.
Date: Measurement stops at the specified time.
Note: If Trigger Repeat has been specified, perform the date and time settings.
Ext.: Measurement is stopped when a signal is input from an external trigger
terminal.
Time: Set the amount of time from the start until the end of measurement. The time
can be specified in 1-s increments.
Event: Measurement stops when all the memory blocks are filled with event capture
data.
Trigger Repeat: Insert a check to enable repeated measurement.
(4) Amp Trigger Settings
Select CH: Select the channel display group.
1 to 8, 9-16
• Start Trigger
CH: Select the channels for which you want to specify a start trigger.
Function: Specify the Trigger Start condition.
Off: Click the "Start" key to start measurement.
Hi: The trigger is activated when the signal input rises to (or exceeds) the specified
upper limit.
Lo: The trigger is activated when the signal input falls to (or goes below) the
specified lower limit.
Win In: The trigger is activated when the signal input goes within (or is within) both
Win Out: The trigger is activated when the signal input goes outside (or is outside)
Upper: Input the signal input value for the upper limit.
Lower: Input the signal input value for the lower limit.
Combination: Select either AND (all conditions met) or OR (any one of the conditions is met)
for the channels for which the Start Trigger has been specified.
• Stop Trigger
CH: Select the channels for which you want to specify a stop trigger.
Function: Specify the Trigger Stop condition.
Off: Click the "Stop" key to stop measurement.
Hi: The trigger is activated when the signal input rises to (or exceeds) the specified
upper limit.
Lo: The trigger is activated when the signal input falls to (or goes below) the
specified lower limit.
Win In: The trigger is activated when the signal input goes within (or is within) both
Win Out: The trigger is activated when the signal input goes outside (or is outside)
Combination: Select either AND (all conditions met) or OR (any one of the conditions is met)
for the channels for which the Stop Trigger has been specified.
limits.
both limits.
limits.
both limits.
Software
4-23
Advertisement
Table of Contents
