Table of Contents
Advertisement
Filter: Use the filter function when you want to cut out noise in the input.
OFF, Line, 5, 50, 500 Hz
Span Upper Limit: Specify the upper limit of the span for the selected range.
Span Lower Limit: Specify the lower limit of the span for the selected range.
Unit: The measurement unit is displayed during measurement.
(4) Logic, Pulse Settings
Logic/Pulse: Specify the condition to be used for measurement.
Off, Logic, Pulse
(5) Logic Settings
Line Color: Specify the color.
Filter: Off: Disabled
On: Enabled
(6) Pulse Settings
Input: OFF, Counts, Revolutions, Inst.
• OFF: Pulses are not measured.
• Counts: Displays the cumulative number of pulses for each sampling interval from the start
of measurement.
• Revolutions: Counts the number of pulses at 1-second intervals and then multiplies them by
a factor of 60 to display them as revolutions.
• Inst.: Counts the number of pulses for each sampling interval.
Line Color: Specify the color.
Range: The range that can be set depends on the mode selected.
Mode
Counts
Revolutions
Inst.
Filter: Off: Disabled
On: Enabled
Slope: Set the condition for the input signal operation.
Hi: Operates when the signal is a rising signal.
Lo: Operates when the signal is a falling signal.
Range
5, 50, 500, 5k, 50k C/F.S.
5, 50, 500, 5k, 50k RPM/F.S.
5, 50, 500, 5k, 50k C/F.S.
Maximum number of pulse inputs
50 k/sampling interval
50k/s
50 k/sampling interval
Software
4-21
Advertisement
Table of Contents
