Table of Contents
Advertisement
Settings and Measurement
CHECKPOINT
When the CH setting is ALL, the Input, Range and Filter settings are the same for all the channels in
that group.
No. of CH ............................ Selects the number of channels for measurement.
Logic/Pulse ......................... Selects whether to use Logic or Pulse measurement.
Input .................................... Selects the input coupling status.
Range ................................. Specifies the range of signal input to be measured.
Filter .................................... Sets the filter status. Please set the filter to ON when there is likely to
3-12
CHECKPOINT
The CRNT and EVNT sampling intervals will differ according to the
number of channels selected. The channels that can be used are
selected automatically.
Off:
Not used
Logic: Enables 4-channel logic measurement.
Pulse: Enables 4-channel pulse measurement.
DC:
Used for measuring direct-current voltage.
TEMP: Used for measuring temperature.
Voltage: 100, 500 mV 1, 5, 10, (50, 100) V
Note: The values in parentheses ( ) can only be used with the 4VF/4MF units.
Temperature (4MF/8MS):
TC-K, TC-J, TC-T, TC-R, TC-E, TC-B, TC-S, TC-N, TC-W
Available SPAN Settings
<Voltage Ranges>
Maximum SPAN
Range Lower to Upper SPAN
[mV]
1
5
10
50
100
–110.00 to +110.00
500
–550.0 to +550.0
<Temperature Ranges>
Maximum SPAN
Range
Lower to Upper SPAN
K
-200.0 to +1370.0
J
-200.0 to +1100.0
T
-200.0 to +400.0
R
0.0 to +1600.0
E
-200.0 to +800.0
B
600.0 to +1820.0
S
0.0 to +1760.0
N
0.0 to +1300.0
W
0.0 to +2315.0
be noise in the input.
Off, Line (1.5 Hz), 5, 50, 500 Hz
Lower to Upper SPAN Upper SPAN minus
[V]
–1.1000 to +1.1000
–5.500 to +5.500
–11.000 to +11.000
–55.00 to +55.00
–110.00 to +110.00
1.0 mV
5.0 mV
Minimum SPAN
Upper SPAN minus Lower SPAN
Minimum SPAN
Lower SPAN
10 mV
50 mV
100 mV
500 mV
1V
50°C
50°C
50°C
50°C
50°C
50°C
50°C
50°C
50°C
Advertisement
Table of Contents
