Gl500 Part Names And Functions - GRAPHTEC GL500 User Manual

2.3 GL500 Part Names and Functions

This section describes the names and functions of parts of the GL500.
(2) Data capture LED (3) Battery charging
LED
(1) Power LED
Top panel
(6) Power connector
(7) Power switch
(8) PCMCIA slot
(1) Power LED .......................... This LED is lit when the power switch is in the 'On' status.
(2) Data capture LED ................ This LED is lit while data is being captured.
(3) Battery charging LED .......... This LED is lit when the battery is being charged.
(4) Monitor ................................ Displays the setting menus and measurement data.
(5) Control panel keys ............... Used for the main operations, including settings, and starting and
(6) Power connector ................. Terminal for connecting the AC/DC power cables.
(7) Power switch ....................... Switch for turning on the power.
(8) PCMCIA slot ........................ Used for inserting the PCMCIA card (PC card).
(9) Logic or Pulse input/alarm output terminal
(10) GND terminal ..................... Connects the main unit to ground.
(11) External trigger terminal .... Terminal for the input of external triggers.
(12) Input terminal units 1 & 2 ... Used to connect the 4VF, 4MF, and 8MS input terminal units.
(13) USB connector terminal .... Terminal for connecting the USB cable.
(14) LAN connector terminal ..... Terminal for connecting the LAN cable.
(15) Monitor control dial ............ Used to adjust the monitor contrast.
(16) Battery ............................... Backup battery used in the case of an AC or DC power failure.
(17) Screwdriver for use with the input terminal units
Note: Attach the LCD protector to the surface of the LCD display when you want to protect it.
(4) Monitor
(9) Logic or Pulse input/alarm
Bottom panel
(13) USB connector terminal
(14) LAN connector terminal
(15) Monitor control dial
stopping measurement.
............................. Used for logic or pulse input and alarm output.
............................. Used to connect the signal input cables to the input terminal units.
(5) Control panel keys
(11) External trigger terminal
Not used
(10) GND terminal
Not used
output terminal
(12) Input terminal unit 1
(16) Battery
Checks and Preparation
(12) Input terminal unit 2
(17) Screwdriver for use with
the input terminal units
2-3