Table of Contents
Advertisement
Stop
Source ................................ Specifies the trigger condition that must be met in order to stop
CHECKPOINT
Please make the following settings when using the Level Trigger function.
• Mode
Off: The level trigger function is disabled.
H: The trigger is activated when the signal input rises to (or exceeds) the specified trigger level.
CH.1
measurement.
Off:
No trigger is used. Instead, measurement is stopped by
pressing the START/STOP key.
Amp→Amp Settings (Level Trigger)
Measurement is stopped when the level trigger condition is
satisfied.
Note: Set the Level condition as the level value of the range (voltage,
temperature) set for the specified channel.
Combination: Sets the output conditions for stopping (ending)
measurement.
OR: Measurement is stopped when one of the output
conditions is satisfied.
AND: Measurement is stopped when all of the output
conditions are satisfied.
Date:
Measurement is stopped at the specified time.
Note: Since measurement stops at the specified time, make sure that the
GL500 time settings are correct. Moreover, if Repeat has been set
to On, data capture will stop at the specified time each day.
Ext.:
Measurement is stopped when a signal is input from an
external trigger terminal.
Time:
Sets the amount of time from the start until the end of
measurement. The time can be specified from 1 second to
9999 hours.
Ev. full: Measurement stops when all the memory blocks are filled with
event capture data.
Measurement starts
Settings and Measurement
3-19
Advertisement
Table of Contents
