Cursor Position ................... The following functions can be selected for Cursor Position.
Search ................................ Searches can be made for a data position that satisfies the specified
Move to First Data: Moves the cursor to the start of the data.
Move to Last Data: Moves the cursor to the end of the data.
Move to Center:
Moves the cursor to the center of the data.
Move to Trigger:
Moves the cursor to a trigger point in the data.
Move to Selected Position:
Moves the cursor to the specified position.
• Position: Moves the cursor at the specified time interval from the
start of measurement. The interval is specified in 0.1-s units
up until the end of measurement.
• Time: Moves the cursor to the specified date and time.
Level condition, the specified Alarm condition, and conditions which
satisfy specific search conditions within the captured data.
Search Settings
• Level Search
CH:
Selects the channels used for setting the Level condition.
Mode: Selects the condition from Off, H, L, Win In or Win Out.
Lower-Level-Upper:
Sets the search levels for captured data.
LP
When pulse data has been captured:
Selects the channel for setting the pulse level.
When logic data has been captured:
Sets the search conditions.
Combination:
Selects the method, OR or AND, for setting the CH and LP
conditions.
• Alarm Search
Alarm output number:
Specify the number that has been set for the alarm settings (1
to 4).
Settings and Measurement
3-35